This paint set is a reproduction of the red transparent paint used by Puch (original part no. 900.0234 / 08).
The red glaze matches the original color 100%.
The set includes 400 ml of silver primer (recreated based on the original sample) and 400 ml of Red Transparent P3052T; the mixing ratio for the glazes is 1:0.7, resulting in 0.68 l ready for spraying.
For the silver primer, the mixing ratio is 1:1, which yields 0.8 L.
It is essential to use two-coat thinner (BC thinner / base coat thinner) as the thinner.
After the moped parts have been prepared as usual, they are coated with a full-coverage layer of the silver primer. After a flash-off time of approximately 30 minutes, apply two to three even coats of the red glaze. Since the amount of glaze applied can alter the color shade, it is recommended to create a color sample first and then paint the moped using the same system!
It is essential to apply a topcoat of two-component clear coat after another 30-minute flash-off time. However, this is not included in the set.
| Puch |
Accessories & related products
Explore categories from Paints & varnishes
Moped fans also bought
swiing® revival Bing float needle (with penetration) SRE, SRC, SRF, SRA, 85, 18
Manufacturer: swiing® revival parts · Component group Carburetor: Adjusting screws, float, etc. · Material: Aluminum · Material: Rubber · Color: black · Color: silver · Ø outside: 2.6 mm · Ø outside: 4 mm · Carburetor type: SRA (1/11/35) Velux · Carburetor type: SRC · Carburetor type: SRE · Carburetor type: SRF · Carburetor type: 18 Catalyst · Carburetor type: 85 · Total length: 12 mm · Width: 3.3 mm · Alternative version of the Pony OEM number: A4595A · Alternative version of the Sachs OEM number: Bing 47-032
CHF 6.90
GPO fork lock | Puch
Ø rotating part: 12 mm · Manufacturer: GPO · Wide locking block: 4.1 mm · Locking block length: 15.3 mm · Material: Brass · Material: Spring steel · Material: Steel · Ø outside: 12 mm · Length of turned part: 25.6 mm · Total length: 40.8 mm · Ø Pin: 8 mm · Width: 17 mm
CHF 10.50
Cable sleeve, Ø 5 x 2.2 mm, black (6-meter roll)
Manufacturer: Made in Italy · Ordering unit: Roll 6 meter · Ø outside: 5 mm · Material: Plastic · Material: Steel · Color: black · Coating: none · Total length: 6000 mm · Ø cable: 2.2 mm · Ø inside: 2.5 mm · Area of application: Standard
CHF 11.90
CHF 1.98/m
swiing® revival mudguard arch 17" front chrome
Ø mounting hole: 5.9 mm · Ø mounting hole: 6.4 mm · Manufacturer: swiing® revival parts · Material: Steel · Outer width: 130 mm · Color: Chrome · Surface: chrome-plated · Distance mudguard - center hole: 212 mm · Distance mudguard - center hole: 247 mm · Ø outside: 14 mm · Total length: 270 mm · Number of fixing points: 6 pcs · Mounting type: Nuts & bolts · Hole spacing: 35 mm · Wheel size: 17 " · Wide intake: 115 mm
CHF 19.90
Working late? Evening hours on Thursday until 20:00
